Data Transfer Helper (DTH)

Data Transfer Helper (DTH) is an independent executable program. It helps you retrieve/update application data through a serial port or Ethernet port

To run the DTH, choose Start > All Programs > “The software” > Data Transfer Helper (DTH).

You can use DTH to download recipe data or OS & AP in a specified file from the PC to the HMI. With DTH, you can also get logged data, logged operations, alarm counts, logged alarms, recipe data, OS & AP from the HMI, and save the data in a specified file on the PC. The following dialog is an example of the Data Transfer Helper:

The following table describes each property in the Download Data to Panel dialog.

Property	Description
Operation Type	Select an operation you want to perform with the target panel
Link Settings	Select the communication port that is used to connect to the target panel.
	Communication Port	Description
	Serial Port (COM)	Use the serial port to perform the operation and select a communication port and the baud rate used.
	Ethernet	Use the Ethernet to perform the operation. Type the IP Address where the target panel is located, or choose a recently connected entry from the list.
Password	Enter a valid password of user level 8 or higher. (* the default password of user level 8 is 88888888)
Status	Display the transmission status and progress.
Abort	Stop the communication
Next	Click the button to start the operation and do the settings for the selected operation if communication is established successfully.
Finish	Exit the dialog.
Cancel	Cancel the operation.